Archive | Advertise | tappi.org March 2018

The Standard-Specific Interest Groups (SSIGs) for the following standards are in need of additional members

Print Print this article | Send to Colleague

All Standard-Specific Interest Groups (SSIG) require a minimum of 10 members in order to ballot and vote on a draft of a method. The following test methods do not have the required minimum number of member to initiate a ballot:

T 245 sp-12 "Silicates and silica in pulp (wet ash method)" requires 3 more SSIG members.

T 602 cm-07 "Analysis of sulfuric acid" requires 2 more SSIG members.

T 408 cm-07 "Rosin in paper and paperboard" requires two more SSIG members to ballot.

T 421 om-12 " Qualitative (including optical microscopic) analysis of mineral filler and mineral coating of paper" requires two more
SSIG  members for ballot.

T 438 cm-06 "Zinc and cadmium in paper" requires two more SSIG members for ballot.

If no progress is made on balancing these SSIGs, then the respective methods may be considered for withdrawal at the next QSMC meeting. If you have an interest in becoming a member of either of these SSIGs please contact standards@tappi.org.

TAPPI Standards guidelines require that all TAPPI members receive notification of any proposed new Standard or TIPs. This message is being sent to you because you are a TAPPI member; have purchased TIPs or Standards products from TAPPI; or because you have previously expressed interest in this topic.

TAPPI

TAPPI is the leading technical association for the worldwide pulp, paper and converting industry.
15 Technology Parkway South | Norcross, GA 30092 | www.tappi.org
1-800-332-8686 (US) | 1-800-446-9431 (Canada) | +1-770-446-1400 (Worldwide)