September 24, 2014

ADCI Informational Update 2014 - 31

Know Your Rigging. Know Your Load.

Safety Checklist for Rigging

There are many different types of rigging devices used internationally for various construction and engineering purposes. These pieces of equipment can be very dangerous if they are not handled and inspected regularly. Each company that uses them has its own set of safety regulations that must comply with government standards and manufacturers’ guidelines.

It is also important to note that there have been certain types of rigging that has been manufactured in other countries that does not meet the safety requirements for its stated load and capabilities. It is critical that end-users inspect and determine where all rigging components have been manufactured to ensure that no one aspect of the rigging will compromise the lifting or tie-down operation. Proper and real-time JHAs should be conducted.

Responsibility

All contractors have their own set of responsibilities to make the workplace safe. This starts with senior management. Company personnel need to be able to identify the correct rigging and techniques to be used. This also includes the proper inspection of the rigging and proper training of personnel.

Safety Techniques

There are specific tasks that personnel must do to ensure that the operation runs as safely as possible. Before operations, always inspect the rigging and machinery. Ensure that the switch limits are not overloaded and that all loads are within the regulation weight. Personnel should ensure that the load is even by determining its center. Additionally, ensure the protection of slings from any sharp corners or edges. Any adjustments to tension should be made accordingly.

Safety Equipment

All personnel should wear proper PPE, as required (gloves, hard hats, steel-toed boots, safety glassed).

ADCI
5206 FM 1960 West, Ste. 202 | Houston, TX 77069
Phone: (281) 893-8388 | Fax: (281) 893-5118